MQX VIRTUAL COM DRIVER

In case no jumper is at hand, there is a trick. Thanks for the good documentation. Now I change the jumpers J12 and J13 to the position:. Cancel reply Enter your comment here Console output on virtual COM port. Hi Bernd, there are a few zero ohm resistors on the board e. Under point 2 it lists my connected board with the firmware version 30 in this case.

Uploader: Meztitaxe
Date Added: 8 March 2008
File Size: 23.93 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 47843
Price: Free* [*Free Regsitration Required]

Thanks for the good documentation.

Maybe this is the problem you are facing? Hi Bernd, there are a few zero ohm resistors on the board e. I have seen recently a growing number of issues with XP especially with driver installations.

Virtual COM/USB CDC for OSBDM/OSJTAG | MCU on Eclipse

But there is a known issue with the bootloader and Windows 8. The works for me under Windows 7. I can run my application virtuao shell support run on a single board, with a single USB connection for powerdebug and console: It is available from http: So I can ask directly for this changes. Notify me of new comments via email.

New Drivers  PSR E413 MIDI DRIVER DOWNLOAD

So to me still Windows 7 is the best choice. Any LEDs light off. Not sure if this would be enough.

USB virtual COM port Demo CDC driver for Windows Vista and 7

The schematics for the board is different: This one was one of the first Tower boards available, and very similar to the TWR one: What do you think? Console output on physical Qmx port.

This site uses Akismet to reduce spam. Now I can use a single connection for power, debug and terminal connectivity. Fill in your details below or click an virtyal to log in: Now I change the jumpers J12 and J13 to the position:.

It happens when I reconnect my board with jumper on. If there is an earlier version of the firmware updater, it needs to be uninstalled first: That is not what I will do. Have a look at https: Without jumper on J16 my device is detected. After everything is installed: That makes my life much simpler and easier. How can I disable this? You are commenting using your Facebook account. Notify me of new posts via email.

New Drivers  SAMSUNG SCL770 DRIVER DOWNLOAD

USB virtual COM port Demo CDC driver for Windows Vista and 7

The simplest thing is to create a Processor Expert project and using the Term component:. Hi Bernd, you can reprogram the JM60 on the board with any firmware you want, there is a BDM connector for it on the board. Regards, Bernd Like Like.

Dialog to enter run mode. Windows will install the drivers for the bootloader if not already installed. Freescale did, there is as well a fom here: